1. Remove all legs
As described in Section 02: Dissasembly for rolling
2. Unplug power cabinet(s)
To remove seat – first unplug all the wires from power cabinet(s) (underneath the floor). Typically power cabinet has 3 cables connected: power cord, control cable (M-Bus with Ethernet plug) and safety button cable (with green plug).

3. Remove seat
To remove seat raise a lid in a wire box (underneath the seat). You can fix the lid temporarily by the front protruding grills. Now you can unscrew 4 corner screws (ones marked at the picture) using Allen key.

Now you can lift the seat from the floor!
4. Dismount power cabinet
When you have the floor without the seat (and steering wheel column – if applicable) you can unscrew power cabinet from underneath the floor.
Remember to support the power cabinet while unscrewing!
Now 2 “legs” with power cabinet are separate and ready to pack for transport!
5. Side panels
Side panels are also removable if necessary.
To remove side panel unplug USB cables of a joystick (or any control device mounted to a panel). Unplug mockup head power cord. and also unplug 2 power button wire using flat screwdriver. Now you can untangle all wires from side panel’s holes.
After this unscrew 5 screws using Allen key.
Secure all the loose cables to the seat base for the transport.
